T.1.1.2 The template will be held horizontally, parallel to the ground, and inserted vertically from a height above any Primary Structure or bodywork that is between the Front Hoop and the Main Hoop until it meets both of: ( refer to F.6.4 and F.7.5.1 ) a. Has passed 25 mm below the lowest point of the top of the Side Impact Structure b. Is less than or equal to 320 mm above the lowest point inside the cockpit
T.1.1.3 Fore and aft translation of the template is permitted during insertion.
T.1.1.4 During this test: a. The steering wheel, steering column, seat and all padding may be removed b. The shifter, shift mechanism, or clutch mechanism must not be removed unless it is integral with the steering wheel and is removed with the steering wheel c. The firewall must not be moved or removed d. Cables, wires, hoses, tubes, etc. must not block movement of the template During inspection, the steering column, for practical purposes, will not be removed. The template may be maneuvered around the steering column, but not any fixed supports. For ease of use, the template may contain a slot at the front center that the steering column may pass through.
T.1.2.2 Conduct of the test. The template: a. Will be held vertically and inserted into the cockpit opening rearward of the rearmost portion of the steering column. b. Will then be passed horizontally through the cockpit to a point 100 mm rearwards of the face of the rearmost pedal when in the inoperative position c. May be moved vertically inside the cockpit
T.1.2.3 During this test: a. If the pedals are adjustable, they must be in their most forward position. b. The steering wheel may be removed c. Padding may be removed if it can be easily removed without the use of tools with the driver in the seat d. The seat and any seat insert(s) that may be used must stay in the cockpit e. Cables, wires, hoses, tubes, etc. must not block movement of the template f. The steering column and associated components may pass through the 50 mm wide center band of the template. For ease of use, the template may contain a full or partial slot in the shaded area shown on the figure